| |
Korrocoat
Polymers H.R. Paint is specially made to withstand heat at
high temperature as well as corrosion,humidity, chemicals,
U.V. radiation & other hazardus normally encountered in
tropical, industrial environment with satisfactory results.
|
Korrocoat H.R. paint withstand temperature
upto 600°c & because of special Silicon based binder
used it does not
get burnt, destroyed, peeled off, corroded. Hence used for
protection of capital equipments, plants structures etc.
besides high temperature it is unaffected by gases, water,
oils, spirit, petrol, steam etc. On applying H.R. Paint
perfect bonding is achieved forming a part of metal/ surface
without affecting the substrate chemically. It forms
water repellent surface, which on curing is rendered washable
to normal dirt, dust, grease & oil stains, foreign
matters using detergents & hot waters.
Morever
Korrocoat Polymers H.R. paint does not showany skinning, separation,
settling & has got good flow
& good finish with very good coverage & excellentadhesion
on properly prepared substrates. The paint shows excellent
film properties even after quenching at a temp of 600°c
for 4 hrs. & the paint is free from toxic compounds such
as Benzene & Organic chlorinated compounds.
|
|
The
outstanding properties of Korrocoat H.R. paints have enabled
a wide range uses some typical applications
are automobile silencers, chimneys, ovens, dryers, furnaces,
lab equipments, storage tanks etc.
|
DIRECTION OF USE :- The
substrate should be properly prepared and should be free from
oil, grease, rust & moisture. The paint should be applied
at 20-25 Sec. viscosity by B-4 ford cup at a thickness of
20-25 microns & flash off of 40-45 minutes should be given
before curing at temperature of 200+100c for about 1 hour.
|
|
KPPL Heat Resistence Paints
| Sr
no |
Test |
Observation |
| 1 |
Composition
|
Silicon
based H.R. Paint |
| 2 |
Skinning,
Settling |
Nil |
| 3 |
Benzene
& Chlorinated Compounds |
Nil |
| 4 |
Shelf
Life |
12
Months |
| 5 |
Supply
Viscosity |
30-35
Sec |
| 6 |
Application
Viscosity |
20-25
Sec |
| 7 |
Recommended
D.F.T. |
20-25
microns. |
| 8 |
N.V.M.
at 1200c/hr |
40
+ 2% |
| 9 |
Specific
gravity |
1.01
+ 0.02 |
| 10 |
Curing
Schedule |
200
+ 100c for 1 hour |
| 11 |
Finish
|
Smooth |
| 12 |
Cross
cut Adhesion |
Passes |
| 13 |
Impact |
Passes
0.908 kg from 40” |
| 14 |
Flexibility |
Passess
¼” |
| 15 |
Salt
Spray |
Passes
96 hrs & does not show red corrosion |
<Back |
|
|
site designed by www.genesism.com